Donaldson Torit CPV-4 Especificações descarregar pdf (Página 10)

Installation, Operation and Maintenance Manual

PowerCore

Dust Collectors – Series CPV

INSTALLATION

Pressure relief

The manifold has a maximum operating pressure of 6.2 bar (see Table 2 in

‘Specifications’ section). It is a requirement that adequate precaution is taken to

avoid exceeding this pressure. Where a relief valve is supplied by Donaldson

this device has a relief rating of 25 dm

/s at 7.1 bar. Extra system relief will be

required if the connected supply can exceed this.

Controller

It is a requirement of the Supply of Machinery (Safety) Regulations

1992 to provide adequate isolation and emergency stop facilities. Due

to the varied nature of site installations this cannot be provided by

Donaldson but instead is the responsibility of the customer.

Always isolate power before opening the controller.

Each CPV dust collector is supplied with an IPC (∆Ρ) Controller to operate the

compressed air cleaning system.

CPV-2: 2-way controller CPV-6: 6-way controller

CPV-3: 3-way controller CPV-8: 8-way controller

CPV-4: 4-way controller CPV-12: 12-way controller

For IPC (∆Ρ) Controller connections and set-up, refer to Publication

2699.

Explosion protection

When PowerCore dust collectors are supplied for use where there is a

risk of explosion within the process, any protection fitted to the process

should not generate pressure exceeding the strength rating of the

collector. For CPV-2, CPV-3, CPV-6 and CPV-12 collectors the strength

rating is 0.23 bar; for CPV-4 and CPV-8 collectors the strength rating is

0.26 bar.

Installation check list 

Ensure the dust collector is securely bolted over the aperture.

Ensure compressed air supply is installed correctly and free from leaks.

Ensure electrical supply is installed correctly and complies to local legislation.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sem comentários

Donaldson Torit CPV-4 Especificações Página 10